Well Logging Short Notes
One-page CSIR NET geophysics revision: invasion, logging modes, resistivity, SP, temperature, sonic, density, neutron, gamma ray, Archie and LWD.
- 7 min read
- Updated
Share this topic
csirnetnotes.com/earth-sciences/well-logging/quick-revision
Pre-written messageWell Logging Short Notes — notes, formulas and practice, free. csirnetnotes.com/earth-sciences/well-logging/quick-revision
Every formula, value and trap from Logging Operations: Open-Hole, Cased-Hole, Production Logging and LWD, Electrical, SP and Temperature Logs, Porosity Logs: Sonic, Density, Neutron and Gamma Ray and Formation Evaluation: Formation Factor, Porosity, Permeability, Saturation and Lithology, on one page.
Part C in one table
Per the NTA information bulletin for December 2026, Earth Sciences Part C:
| Given | Attempt | Correct | Wrong | Maximum |
|---|
| 80 | 25 | +4 | −1.32 | 100 |
Only the first 25 answered questions are evaluated. Full pattern on the Earth Sciences overview.
Borehole environment
| Zone (outward) | Resistivity | Saturation |
|---|
| Mud | \( R_m \) | — |
| Mud cake | \( R_{mc} \) | — |
| Flushed zone | \( R_{xo} \) (filtrate \( R_{mf} \)) | \( S_{xo} \) |
| Transition zone | \( R_i \) | mixed |
| Uninvaded zone | \( R_t \) (water \( R_w \)) | \( S_w \) |
- Mud cake forms only opposite permeable beds (caliper under bit size).
- Deeper reading = poorer vertical resolution.
| Hole | Cannot run |
|---|
| Oil-based mud | SP, laterolog |
| Air-filled | SP, laterolog, sonic |
| Cased | SP, conventional resistivity, induction, conventional density |
Logging modes
| Mode | Key logs |
|---|
| Open hole | caliper, GR, SP, shallow/medium/deep resistivity, density + Pe, neutron, sonic; images, NMR, testers, sidewall cores |
| Cased hole | GR + CCL (depth), CBL/VDL and ultrasonic (cement), neutron, pulsed-neutron sigma, C/O, casing inspection |
| Production | spinner, temperature, pressure, fluid density, capacitance/holdup, noise, tracer |
| LWD | GR, propagation resistivity, density/neutron, sonic, NMR, pressure, images; MWD gives direction |
- CBL: low amplitude = good bond; free pipe = high amplitude, straight casing arrivals.
- Sigma: high in saline water (chlorine), low in hydrocarbon.
$$\boxed{\Sigma_{\log} = (1 - \phi)\Sigma_{ma} + \phi S_w\Sigma_w + \phi(1 - S_w)\Sigma_h}$$
- C/O: inelastic gamma, carbon about 4.4 MeV, oxygen about 6.1 MeV; independent of salinity.
$$\boxed{Q = C\,v_a\,A}\quad C \approx 0.83 \text{ (turbulent)},\ 0.5 \text{ (laminar)};\qquad \boxed{y_w = \frac{\rho_m - \rho_o}{\rho_w - \rho_o}}$$
- Zone contribution = flow above − flow below; percentages straight from velocity differences.
- Holdup exceeds water cut in upflow (oil slips past water).
- Gas entry: cooling anomaly.
- LWD: time after bit = offset ÷ ROP; less invasion; geosteering; mud-pulse telemetry (slow), EM, wired pipe, memory. Phase-shift resistivity shallow, attenuation deep.
$$\boxed{R_2 = R_1\frac{T_1 + 21.5}{T_2 + 21.5}\ (^\circ\text{C})}\qquad T_f = T_s + gD$$
| Tool | Physics | Best in |
|---|
| Normal / lateral | unfocused electrodes; \( R_a = 4\pi\overline{AM}\,\Delta V/I \) | historic; conductive mud |
| Laterolog (LLd, LLs, MSFL) | focused current; series \( R \approx JR_{xo} + (1-J)R_t \) | salty mud, high \( R_t \), thin beds |
| Induction | coils, eddy currents; parallel \( 1/R \approx G/R_{xo} + (1-G)/R_t \) | fresh or oil mud, air; low–moderate \( R_t \) |
| Microlog | micro-inverse vs micronormal | positive separation = mud cake = permeable |
| Mud and zone | Shallow vs deep |
|---|
| Fresh mud, water | \( R_{xo} > R_t \) |
| Salty mud, water | \( R_{xo} \approx R_t \) |
| Salty mud, hydrocarbon | \( R_t > R_{xo} \) |
Spontaneous potential
$$\boxed{\text{SSP} = -K\log_{10}\frac{R_{mf}}{R_w}},\qquad K \approx 65 + 0.24\,T(^\circ\text{C}) = 61 + 0.133\,T(^\circ\text{F});\ K = 71 \text{ at } 25\,^\circ\text{C}$$
- Sources: membrane (shale, cation-selective, larger) + liquid junction (Cl⁻ faster than Na⁺) + small electrokinetic.
- \( R_{mf} > R_w \): negative; \( R_{mf} < R_w \): positive; equal: flat.
- \( V_{sh} \approx 1 - \text{PSP}/\text{SSP} \); bed boundaries at inflection points.
- Reduced by thin beds, shale, high \( R_t/R_m \), hydrocarbons.
- Worked case: 75 °C, SSP −83 mV, \( R_{mf} = 0.60 \) → \( K = 83 \), \( R_w = 0.060 \) Ω·m.
Temperature logs
- \( dT/dz = q/k \): steep in low-conductivity shale, gentle in salt and sandstone; high in undercompacted shale.
- Horner: BHT vs \( \log[(t_c + \Delta t)/\Delta t] \); intercept at ratio 1 = static temperature (always above any BHT).
- Cement top: warm (hydration). Gas entry: cold. Lost circulation: cold. Injection zones: slow warm-back.
Porosity logs
| Matrix | \( \Delta t \) (µs/ft) | \( \rho_{ma} \) (g/cm³) | Pe (b/e) |
|---|
| Sandstone | 55.5 | 2.65 | 1.81 |
| Limestone | 47.5 | 2.71 | 5.08 |
| Dolomite | 43.5 | 2.87 | 3.14 |
| Anhydrite | 50.0 | 2.98 | 5.05 |
| Halite | 67.0 | 2.04 | 4.65 |
| Water | 189 | 1.0 | 0.36 |
$$\boxed{\phi_S = \frac{\Delta t - \Delta t_{ma}}{\Delta t_f - \Delta t_{ma}}}\qquad\boxed{\phi_D = \frac{\rho_{ma} - \rho_b}{\rho_{ma} - \rho_f}}\qquad\boxed{\phi_{gas} \approx \sqrt{\frac{\phi_N^2 + \phi_D^2}{2}}}$$
- \( v = 304{,}800/\Delta t \) m/s. Raymer (simplified) \( \phi \approx C(\Delta t - \Delta t_{ma})/\Delta t \), \( C \approx 0.625\text{–}0.70 \).
- Sonic misses vugs and fractures: SPI \( = \phi_{ND} - \phi_S \).
- Density: Cs-137, 662 keV, Compton, electron density; \( \rho_a = 1.0704\rho_e - 0.1883 \).
- Neutron: Am-Be, hydrogen index, limestone units; sandstone reads low, dolomite high, shale high, gas low.
| Overlay (limestone scale) | Meaning |
|---|
| Overlay | clean liquid-filled limestone |
| Density > neutron (crossover) | gas (small crossover: clean sandstone) |
| Neutron ≫ density, high GR | shale |
| Neutron > density, low GR, Pe ≈ 3 | dolomite |
Gamma ray
$$\boxed{I_{GR} = \frac{GR - GR_{\min}}{GR_{\max} - GR_{\min}}}\qquad V_{sh} = 0.083(2^{3.7I} - 1)\ \text{(Tertiary)},\ 0.33(2^{2I} - 1)\ \text{(older)}$$
- K-40 1.46 MeV, U (Bi-214) 1.76 MeV, Th (Tl-208) 2.61 MeV.
- Radioactive non-shales: arkose, mica, glauconite, uraniferous sands, ash. Hot shales: high U, organic-rich.
- Shapes: cylinder, bell (fining up), funnel (coarsening up), serrated.
- Worked case: \( I_{GR} = 0.5 \) → Larionov Tertiary 0.22, older 0.33.
$$\boxed{F = \frac{R_o}{R_w} = \frac{a}{\phi^m}}\qquad\boxed{S_w = \left(\frac{aR_w}{\phi^m R_t}\right)^{1/n}}\qquad\boxed{S_{xo} = \left(\frac{aR_{mf}}{\phi^m R_{xo}}\right)^{1/n}}$$
| Item | Fact |
|---|
| Constants | \( a = 1 \), \( m = n = 2 \); Humble \( 0.62/\phi^{2.15} \) |
| \( m \) | about 1.3 unconsolidated; higher for vugs; lower for fractures |
| \( n \) | about 2 water-wet; higher oil-wet |
| \( R_{wa} \) | \( R_t/F \); minimum = \( R_w \); \( R_{wa} \ge 4R_w \) → \( S_w \le 0.5 \) |
| Pickett | log \( R_t \) vs log \( \phi \): slope \( -m \); water line at \( aR_w \) for \( \phi = 1 \) |
| Movability | \( S_w/S_{xo} \ll 1 \) moveable; residual HC \( = 1 - S_{xo} \) |
| Ratio method | \( R_{xo}/R_t = (R_{mf}/R_w)(S_w/S_{xo})^n \) |
| BVW | \( \phi S_w \); constant → irreducible |
| Shaly sand | clean Archie over-estimates \( S_w \); Simandoux, Indonesia, Waxman–Smits, dual water |
| Permeability | Timur \( k = 0.136\phi^{4.4}/S_{wi}^2 \) (md, %); NMR; testers; not measured directly |
| M–N | \( M = 0.01(\Delta t_f - \Delta t)/(\rho_b - \rho_f) \), \( N = (\phi_{Nf} - \phi_N)/(\rho_b - \rho_f) \) |
| Apparent matrix | \( \rho_{maa} = (\rho_b - \phi\rho_f)/(1 - \phi) \); \( U_{maa} \): 4.8 quartz, 9.0 dolomite, 13.8 calcite |
| Pay | HPT \( = \sum h\phi(1 - S_w) \) |
- Worked case: \( \phi = 0.20 \), \( R_w = 0.05 \), \( R_t = 20 \) → \( F = 25 \), \( R_o = 1.25 \), \( S_w = 0.25 \).
- Worked case: \( \phi = 25\% \), \( S_{wi} = 20\% \) → Timur \( k \approx 480 \) md.
Back to the chapter
Return to the Well Logging overview, or revise reservoirs and volumetrics in Petroleum Geology and Indian Basins.